Lenovo ThinkSystem RAID 530 Series Internal RAID AdaptersProduct Guide

Author
Published
11 Jul 2017
Form Number
LP0651
PDF size
10 pages, 547 KB

Abstract

The ThinkSystem RAID 530 family are entry-level 12 Gb SAS/SATA internal RAID adapters that offer a cost-effective RAID solution for small to medium business customers. These cacheless adapters support RAID levels 0/1/10/5/50, and include an extensive list of RAS and management features.

This product guide provides essential presales information to understand the ThinkSystem RAID 530-4i and 530-8i adapters and their key features, specifications, and compatibility. This guide is intended for technical specialists, sales specialists, sales engineers, IT architects, and other IT professionals who want to learn more about the adapters and consider their use in IT solutions.

Introduction

The ThinkSystem RAID 530 family are entry-level 12 Gb SAS/SATA internal RAID adapters that offer a cost-effective RAID solution for small to medium business customers. These cacheless adapters support RAID levels 0/1/10/5/50, and include an extensive list of RAS and management features.

The family is comprised of two adapter types:

  • The ThinkSystem RAID 530-4i supports up to four internal SAS and SATA drives
  • The ThinkSystem RAID 530-8i supports up to eight internal SAS and SATA drives

The ThinkSystem RAID 530-8i is shown in the following figure.

ThinkSystem RAID 530-8i PCIe 12Gb Adapter
Figure 1. ThinkSystem RAID 530-8i PCIe 12Gb Adapter

Did you know?

Along with an extensive list of enterprise RAID capabilities, the RAID 530 Series adapters offer advanced drive diagnostic technologies. In the event of a physical drive failure, the drive is placed in a shielded state and the controller starts drive diagnostics to determine if the drive is indeed failed or can be restored. This saves time, money and server downtime associated with transient drive failures and unnecessary drive replacement.

Part number information

The following table provides the ordering part numbers for the adapters.

Table 1. Part numbers and feature codes
Part number Feature code Description
7Y37A01082 AUNG ThinkSystem RAID 530-8i PCIe 12Gb Adapter
7M27A03918 AUYR ThinkSystem RAID 530-4i 2 Drive Adapter Kit for SN550
7M17A03932 AVEC ThinkSystem RAID 530-4i 4 Drive Adapter Kit for SN850
None* AUYK ThinkSystem SD530 HW RAID Kit (530-8i for SD530)

* Available only in preconfigured models or configure-to-order

The following figure shows the ThinkSystem SD530 HW RAID adapter.

ThinkSystem SD530 HW RAID adapter
Figure 2. ThinkSystem SD530 HW RAID adapter

Technical specifications

The ThinkSystem RAID 530 Series internal RAID adapters have the following specifications:

  • PCIe 3.0 x8 host interface
  • 12 Gbps SAS/SATA RAID controllers, based on the Broadcom MegaRAID 9440 adapter family
  • Cacheless (not upgradeable)
  • Connectivity for up to 4, or 8 internal SAS or SATA drives
  • Support for intermixing SAS and SATA HDDs and SSDs. Mixing SAS and SATA drives in the same array is not supported. Mixing of HDDs and SSDs in the same array is not supported.
  • Support for intermixing of 12 Gbps and 6 Gbps drives.
  • Support for RAID 0, 1, 10, 5, and 50 standard (The 530-4i supports only RAID 0, 1 in the SN550 and RAID 0, 1, 10, 5 in the SN850 because those blade servers only support two and four drives respectively)
  • Support for JBOD (non-RAID) drive state
  • Support for up to 64 virtual disks, up to 128 arrays, up to 16 virtual disks per array
  • Support for logical drive sizes greater than 2 TB.
  • Configurable stripe size from 64 KB up to 1 MB
  • Supports 512e, 512n and 4K sector formatted drives
  • Compliant with Disk Data Format (DDF) configuration on disk (CoD).
  • S.M.A.R.T. support.
  • Configuration through
    • XClarity Provisioning Manager UEFI interface
    • XClarity Controller web interface
    • XClarity Administrator Configuration Patterns
    • StorCLI command-line interface
    • LSI Storage Authority (LSA) GUI interface
    • UEFI Human Interface Infrastructure (HII)

Note: CacheCade is not supported by these adapters

The following table compares the specifications of the RAID 530 internal adapters.

Table 2. Specifications
Feature SD530 adapter RAID 530-4i RAID 530-8i
Part number Feature AUYK 7M27A03918
7M17A03932
7Y37A01082
Form factor Custom Custom PCIe low profile
Controller chip LSI SAS3408 LSI SAS3404 LSI SAS3408
Host interface PCIe 3.0 x8 PCIe 3.0 x8 PCIe 3.0 x8
Port interface 12 Gb SAS 12 Gb SAS 12 Gb SAS
Number of ports 6 2 or 4† 8
Port connectors 2x SlimSAS x4 1x Mini-SAS HD x4
(SFF-8643)
2x Mini-SAS HD x4
(SFF-8643)
Drive interface SAS, SATA SAS, SATA SAS, SATA
Drive type HDD, SSD HDD, SED, SSD HDD, SED, SSD
Hot-swap drives Yes Yes Yes
Max devices 6 2 or 4† 8
RAID levels 0, 1, 10, 5, 50 0, 1, 10, 5† 0, 1, 10, 5, 50
JBOD mode Yes Yes Yes
Cache None None None
CacheVault cache protection No No No
Performance Accelerator (FastPath) No Yes Yes
SED support (SafeStore) Yes Yes Yes

† The 530-4i adapter for use in the SN550 blade server only supports RAID 0 and RAID 1 because the server has only two drives. The 530-4i adpater for use in the SN850 blade server only supports RAID 0, 1, 5 and 10 because the server has only four drives.

Features

The ThinkSystem RAID 530 adapters have the following standard features:

  • MegaRAID FastPath SSD performance acceleration

    MegaRAID FastPath software provides high-performance I/O acceleration for SSD-based virtual drives by using a low latency I/O path to increase the maximum I/O per second (IOPS) capability of the controller. This feature boosts the performance of applications with a highly random data storage access pattern, such as transactional databases.

  • Auto-resume on array rebuild or array reconstruction after the loss of system power

    Auto-resume uses non-volatile RAM (NVRAM) to save the rebuild progress during a host reboot or power failure to automatically resume from the last checkpoint. Auto-resume ensures that data integrity is maintained throughout the process. The card supports a number of features that can be implemented without rebooting the server. Applications, such as email and web server, benefit from avoiding downtime during the transition.

  • Online Capacity Expansion

    Online Capacity Expansion (OCE) allows the capacity of a virtual disk to be expanded by adding new physical disks or making use of unused space on existing disks, without requiring a reboot.

  • Online RAID Level Migration

    Online RAID Level Migration (RLM), which is also known as logical drive migration, can migrate a virtual disk from any RAID level to any other RAID level without requiring a reboot. System availability and application functionality remain unaffected.

  • Fast initialization for quick array setup

    Fast initialization quickly writes zeros to the first and last sectors of the virtual drive. This feature allows you to immediately start writing data to the virtual drive while the initialization is running in the background.

  • Consistency check for background data integrity

    Consistency check verifies that all stripes in a virtual disk with a redundant RAID level are consistent. The consistency check mirrors data when an inconsistent stripe is detected for RAID 1 and re-creates the parity from the peer disks for RAID 5 or RAID 6. Consistency checks can be scheduled to take place periodically.

  • Extensive online configuration options and advanced monitoring and event notification

    Management tools provide convenience for the configuration of logical volumes and alerting when errors have occurred or are about to occur.

  • Patrol read for media scanning and repairing

    Patrol read is a background sentry service that pro-actively discovers and corrects media defects (bad sectors) that arise normally as a disk drive ages. The service issues a series of verify commands, and if a bad block is discovered, the card's firmware uses RAID algorithms to re-create the missing data and remap the sector to a good sector. The task is interruptible based on controller activity and host operations. The firmware also provides an interface where the patrol read task can be initiated, set up for continuous operation, and terminated from a management application. Patrol read can be activated by a manual command or automatically.

  • Global and dedicated hot spare with revertible hot spare support

    A hot spare rebuilds data from all virtual disks within the disk group in which it is configured. You can define a physical disk as a hot spare to replace a failed drive. Hot spares can be configured as either global or dedicated. A global hot spare allows any physical drive to be designated as a hot spare. A dedicated hot spare allows the user to assign a hot spare drive to a particular array of the same drive type.

  • Drive roaming

    Drive roaming occurs when the physical disks are changed to different ports on the same controller. When the drives are placed on different channels, the controller detects the RAID configuration from the configuration data on the drives.

  • MegaRAID SafeStore support for self-encrypting drive (SED) services

    MegaRAID SafeStore encryption services offer instant secure erase and local key management for self-encrypting drives. This technology represents a step forward in securing data on a disk drive from any unauthorized access or modification resulting from theft, loss, or repurposing of drives. Instant secure erase permanently removes data when repurposing or decommissioning SEDs. SafeStore local key management provides the necessary management and protection of SEDs by using a simple pass phrase, security key identifier, and security key file that can be set and applied to all SEDs that are assigned to a RAID adapter. This feature removes the complexity of managing each SED’s unique encryption key, and it essentially relieves the administrator of most of the daily tasks of securing data.

  • XClarity Provisioning Manager for pre-boot array configuration and management

    Provisioning Manager is the ThinkSystem UEFI-based application that includes a RAID setup wizard to help you configure drive groups and virtual disks before installing or booting the operating system.

  • XClarity Controller web interface for remote storage management

    XClarity Controller (XCC) is the systems management processor integrated in all ThinkSystem servers. The XCC web interface allows you to perform storage inventory, create and edit virtual disks, view events, import a new controller configuration, and perform firmware updates on the adapter.

Note: MegaRAID CacheCade and MegaRAID Storage Manager are not supported.

Server support

The following tables list the ThinkSystem servers that are compatible.

Table 3. ThinkSystem server support
Part
number
Description
ST550 (7X09 / 7X10)
SR530 (7X07 / 7X08)
SR550 (7X03 / 7X04)
SR570 (7Y03 / 7Y04)
SR590 (7X98 / 7X99)
SR630 (7X01 / 7X02)
SR650 (7X05 / 7X06)
SR850 (7X18 / 7X19)
SR860 (7X69 / 7X70)
SR950 (7X11 / 7X12 / 7X13)
SD530 (7X21)
SN550 (7X16)
SN850 (7X15)
7Y37A01082 ThinkSystem RAID 530-8i PCIe 12Gb Adapter Y Y Y Y Y Y Y Y Y Y N N N
7M27A03918 ThinkSystem RAID 530-4i 2 Drive Adapter Kit for SN550 N N N N N N N N N N N Y N
7M17A03932 ThinkSystem RAID 530-4i 4 Drive Adapter Kit for SN850 N N N N N N N N N N N N Y
Feature AUYK ThinkSystem SD530 HW RAID Kit N N N N N N N N N N Y N N

The following figure shows the ThinkSystem RAID 530-4i adapter for both the SN550 and the SN850 blade servers. Note that the plastic frame in the lower right of the adapter is part of the mechanism that attaches the adapter to the server; the adapter does not support a supercapacitor.

ThinkSystem RAID 530-4i adapter for Flex
Figure 3. ThinkSystem RAID 530-4i adapter for Flex (included heatsink not shown)

Operating system support

The ThinkSystem RAID 530 Series adapters support the following operating systems:

  • Microsoft Windows Server 2012 R2
  • Microsoft Windows Server 2016
  • Red Hat Enterprise Linux 6 Server x64 Edition
  • Red Hat Enterprise Linux 7
  • SUSE Linux Enterprise Server 11 for AMD64/EM64T
  • SUSE Linux Enterprise Server 11 with Xen for AMD64/EM64T
  • SUSE Linux Enterprise Server 12
  • SUSE Linux Enterprise Server 12 with XEN
  • VMware vSphere ESXi 6.0
  • VMware vSphere ESXi 6.5

For more information about the specific versions and service levels that are supported and any other prerequisites, see the ServerProven website: http://www.lenovo.com/us/en/serverproven

Warranty

The adapters carry a 1-year limited warranty. When installed in a supported ThinkSystem server, the adapter assumes the server’s base warranty and any warranty upgrades.

Operating environment

The ThinkSystem RAID 530 Series adapters are supported in the following environment:

  • Operating:
    • Temperature: 10°C to 55°C (50°F to 131°F)
    • Relative humidity: 20% to 90% (non-condensing)
  • Storage
    • Temperature with package: -40°C to 70°C (-40°F to 158°F)
    • Relative humidity: 5% to 95% (non-condensing)

Agency approvals

The ThinkSystem RAID 530 adapters have the following agency approvals:

  • FCC Part 15 Class A
  • Australia/New Zealand (AS/NZS CISPR 22)
  • Canada (ICES-003 Class B)
  • Europe (EN55022/EN55024)
  • Japan (VCCI V-3)
  • Korea (RRA no 2013-24 & 25)
  • RoHS compliant
  • EN/IEC/UL 60950
  • Taiwan (CNS 13438)
  • USA (FCC 47 CFR part 15 Subpart B class B)
  • WEEE

Related product families

Product families related to this document are the following: